How to align the CR-10S Pro leveling sensor?

How to align the CR-10S Pro leveling sensor?

Written by Mike Santifort on 19/03/2019 00:00:00

Hello,

Today we are going to explain how to correctly align the CR-10S Pro leveling sensor.

We can start by unscrewing the metal fan holder,
Then we get access to the place where the sensor is attached to the moving head.

 

Now it's the trick to lower the nozzle on to the bed and loosen the 2 grip screws on the left side of the sensor,
then lower the sensor until 3mm off the bed and fasten the 2 grip screws.

 

After that we lower the sensitivity of the leveling sensor and we redo the z homing process, redo this until it lowered the nozzle to touch the bed.

 

If you have done this correctly the leveling sensor will behave way more accurate and you would have to less re-calibrate the leveling!

You're done, enjoy a much smoother leveling process!

Newsletter

Inserisci il tuo indirizzo email per rimanere aggiornato sul mondo della stampa 3D

Perché ReprapWorld?
  • Ordini spediti nello stesso giorno lavorativo
  • Più di 3.000 prodotti a catalogo
  • Più di 45.000 clienti soddisfatti in più di 40 paesi
  • Pagamenti sicuri con qualsiasi metodo
  • Supporto tecnico professionale (più di 10 anni di esperienza nel campo della stampa 3D)
Paga in sicurezza utilizzando


home
Copyright 2009 - 2023 | ReprapWorld